A whole-house device sits at the electrical panel and cuts spikes entering the home on the service line, while a point-of-use unit protects only what is plugged into it. Many homes with costly electronics use both: one at the service, one at each valuable outlet. Whole-house devices are a job for a licensed electrician.

SpecWhole-house (service entrance)Point-of-use (plug-in)
Where it sitsAt or next to the main panelAt the outlet, between wall and device
What it coversEvery circuit on the panelOnly the devices plugged into it
Installed byLicensed electricianYou
ReplacementWhole unit, by an electricianSwap it like a power strip
Protects data lines (coax, Ethernet)No, unless it says soOnly if the product lists those ports

What Each One Does

Whole-house (service-entrance)

This is a surge protective device wired at the service, so spikes arriving from the utility line are reduced before they reach branch circuits. We cover the concept only. Wiring one means working inside the panel, so hire a licensed electrician and ask them to match the unit to your panel. The National Electrical Code (NEC) 2020 edition, section 230.67, requires an SPD on services supplying dwelling units, Type 1 or Type 2, integral to or next to the service equipment. Your state or city may adopt a different code year, so confirm with your local code office or a licensed electrician.

Point-of-use (plug-in)

This is the strip or wall tap that you already know. It sits close to the equipment and clamps what gets past the panel. UL says a surge protective device in a power strip must comply with UL 1449, so look for that listing on the label. Two points help here: it protects lines such as coax or Ethernet only if the product lists those ports, and it wears out as it absorbs surges. Start with surge protector vs power strip if you need the basics.

Coverage Math for a Typical House

Count what you would pay to replace. Suppose a house has a refrigerator, a washer and dryer, a furnace blower control board, a home office, and a TV room. A panel device covers all 5 groups in one shot. Plug-in units cover one location each, so the office, TV room, and fridge need 3 separate units, and anything hardwired has no plug-in option. Add the cost of each and compare with one electrician visit plus the device; prices vary by region, so get a quote.

Do not count on either choice to stop a direct lightning strike; ratings describe typical surges, and a direct strike can exceed them.

Choose Whole-House If

  • Your area has frequent storms or utility switching and you own gear on many circuits (HVAC, appliances, heat pump).
  • You are replacing the panel or service equipment anyway; the NEC section above is aimed at that moment.
  • You want a base layer that does not depend on remembering to plug into the right strip.

Choose Point-of-Use If

  • You rent, or you cannot get an electrician in right now.
  • You protect a few valuable items: computers, NAS drives, TVs; see surge protectors for computers.
  • Avoid if it would be your only layer for a refrigerator or HVAC board with no plug-in access; ask about the panel device or see surge protectors for refrigerators.

FAQ

Do I still need strips if I have a whole-house unit?

Usually yes for sensitive electronics. The panel device reduces spikes at the service, and a nearby plug-in unit adds protection at the outlet for what gets past the panel. Treat it as layers.

Can I install a whole-house surge protector myself?

No. It connects inside the electrical panel. Use a licensed electrician and a permit where your local rules ask for one.

Does a battery backup replace either one?

It depends on the product. A UPS adds outage ride-through and some surge handling; see UPS vs surge protector. It does not cover the rest of the house.

Changelog: November 2026: first published.