Pass-through charging is a power station’s ability to run plugged-in devices while the station itself is being charged from a wall outlet, solar panels, or a car, so the same unit can feed a load and refill its battery at the same time.

Many current power stations support it, but they do not all handle the incoming power the same way, and that difference affects heat, battery wear, and how much load the station can carry while plugged in.

Two Ways a Station Handles Pass-Through

The power either goes around the battery or through it. BLUETTI, a power station maker, describes both designs in its own explainer on the feature and promotes bypass as its approach.

  • Bypass: incoming power goes straight to the connected devices, and only the surplus charges the battery. The cells sit mostly idle, which keeps heat and cycling down.
  • Battery cycling: incoming power charges the battery, and the battery feeds the devices. Every watt is converted twice, which adds heat and puts the cells to work the whole time.

Not every spec sheet says which design a model uses. The manual’s section on AC charging or UPS mode is the place to look, and some list a separate bypass output limit: Anker’s US user guide for the original SOLIX C1000 lists AC output in bypass mode at 1,440 W max (120 V, 12 A), versus 1,800 W from the inverter.

Why It Matters at Home

Pass-through is what lets a station stay plugged in and connected to a fridge, router, or CPAP every day, ready for an outage, instead of sitting unplugged in a closet. It is also the basis of UPS mode: a station in UPS mode runs your devices on pass-through power and switches them to battery when the wall power drops, within a published switchover time such as 10 ms on the EcoFlow DELTA 3 Plus or 20 ms or less on the Jackery Explorer 1000 v2.

With solar, pass-through works as an energy budget. A 300 W daytime load on a station receiving 400 W from panels leaves 400 W minus 300 W = 100 W going into the battery. If clouds cut the panels to 200 W, the battery covers the gap: 300 W minus 200 W = 100 W drawn from storage. Four hours of that shade use 100 x 4 = 400 Wh, about 40 percent of a 1,024 Wh station before inverter losses.

Limits to Check

  • Pass-through output limit: the load a station carries while charging from AC can be lower than its battery output rating. Check the manual or spec sheet for a bypass figure.
  • Charging slows under load: on bypass designs, the battery only gets what the load leaves over, so a heavy load stretches recharge time.
  • Heat: charging and discharging together make the fans run more. Keep the vents clear and the station off carpet.
  • Medical devices: Anker’s SOLIX F1500 manual says the product is not intended for use where failure could affect a medical or life-support device, and Jackery says it does not recommend its power stations, including the Explorer 1000 v2, for medical devices. Ask the device maker or your doctor before relying on pass-through for a CPAP.

Pass-Through vs UPS Mode vs a Wall Outlet

SetupDevice keeps running when the grid drops?Battery stays topped up?
Device on the wall outletNoNot involved
Pass-through only, slow switchoverDepends on the model; any gap may reset sensitive electronicsYes
UPS mode with a 10 to 20 ms switchoverYes for most electronicsYes

For the switchover side in more detail, see what UPS mode on a power station is. To set up solar charging that feeds a load during the day, follow how to charge a power station with solar, and for stations ranked on output, capacity, and charging, see the best portable power stations for home backup.

Changelog: November 2026: first published.