A UPS (uninterruptible power supply) battery backup is a plug-in box with a built-in battery that keeps electronics running for a few minutes when the power drops, switching over fast enough, typically within about 10 milliseconds, that a computer or router does not shut off. Its job is to bridge the gap: long enough to save work and shut down cleanly, or to keep a modem and router online through a short flicker.

What a UPS does for a homeowner

A UPS handles the short outages and voltage dips behind many nuisance restarts. A desktop PC that loses power for a fraction of a second reboots and can lose open files; a router that reboots drops your internet, and any Wi-Fi leak sensors or cameras with it, until it finishes restarting. A UPS covers both, and most models also include surge protection. For the router case specifically, see our guide to the best UPS for a modem and router.

How a UPS works: three designs

Every UPS charges a battery from the wall and runs an inverter from that battery when needed. The three common designs differ in when the battery takes over, as Eaton’s UPS topology paper describes:

DesignHow it worksTypical home use
Standby (offline)Passes wall power through until it detects a problem, then switches to batteryRouters, modems, a home office PC
Line-interactiveBoosts or trims voltage during sags and surges before falling back to batteryHomes with frequent brownouts
Online (double conversion)Converts all power AC to DC and back, so the load always runs from the inverterServers and sensitive equipment

Most consumer units are standby or line-interactive. APC’s Back-UPS BE600M1, a common entry model, is rated 600 VA and 330 W, with a transfer time of 6 ms typical and 10 ms maximum on its datasheet.

How long a UPS runs: minutes, not hours

A small UPS runs for minutes because its battery is small. The BE600M1 uses APC’s APCRBC154 cartridge, a 12 V, 6.5 Ah lead-acid battery, which is 12 x 6.5 = 78 Wh on the label. Retailer listings give about 12 to 15 minutes at half load (165 W), depending on the listing. That works out to 165 W x (12 / 60) = about 33 Wh to 165 W x (15 / 60) = about 41 Wh delivered, roughly half the label or less, partly because lead-acid batteries give up less energy when drained quickly. Light loads such as a 15 W router drain the battery more slowly and stretch further, so check APC’s runtime chart for your exact wattage.

UPS battery life expectancy

Plan to replace a UPS battery every 3 to 5 years. Schneider Electric’s APC support FAQ says most APC batteries should last three to five years, and that every 8°C (15°F) rise in temperature cuts battery life in half. Keep the unit off a hot floor behind a gaming PC, and replace the cartridge when the unit shows its replace-battery warning, whatever its age.

UPS vs a power station with UPS mode

A UPS is built for fast switching and short runtime; a portable power station with UPS mode trades a slower or similar switchover for far more stored energy. A 1,024 Wh station such as the EcoFlow DELTA 3 Classic, which EcoFlow lists with a 10 ms UPS switchover, holds about 1,024 / 78 = about 13 times the label energy of the BE600M1 battery, and uses lithium iron phosphate cells instead of lead-acid. It is also larger and heavier. Our explainer on UPS mode on a power station compares switchover times across models.

Small UPSPower station with UPS mode
Stored energyTens of WhAbout 1,000 Wh and up
Runtime on a routerMinutes to a few hours, depending on loadAbout a day or more
BatterySealed lead-acid, replace every 3 to 5 yearsUsually LiFePO4
Best useClean shutdown, short flickersRiding out a multi-hour outage

Neither one replaces a plan for a long outage. For that, start with how to prepare for a power outage and our list of power outage essentials.

Changelog: November 2026: first published.