A hygrometer is an instrument that measures the amount of water vapor in the air, and most home models report it as relative humidity (RH): the percentage of the moisture the air could hold at its current temperature. A small digital hygrometer on a basement shelf tells you whether the space sits inside the EPA’s recommended range of 30 to 50 percent, or above the 60 percent ceiling the agency recommends staying under.

Why a homeowner needs one

You cannot judge humidity by feel with any accuracy, and the numbers drive real decisions. EPA advises keeping indoor humidity below 60 percent, ideally 30 to 50 percent, and notes that an inexpensive humidity meter from a hardware store is enough to check. ENERGY STAR gives the same 30 to 50 percent band and suggests 30 to 40 percent during the heating season. A reading tells you whether you need a dehumidifier, whether the one you own is keeping up, and whether a room is drifting up after a leak.

Place at least one away from the dehumidifier. The humidistat built into a dehumidifier reads the air right at the unit, which may be drier than the far corners of the room. A separate hygrometer in the far corner, near the foundation wall, shows what the rest of the space is doing.

Types of hygrometers

TypeHow it reads humidityWhere it fits
Digital (capacitive)A sensor whose electrical capacitance changes as it absorbs moistureMost home units, Wi-Fi sensors with phone alerts
Mechanical dialA hair or coil element that stretches and shrinks with moisture and moves a needleDecor gauges, humidors; drift is common
PsychrometerCompares a wet-bulb and a dry-bulb thermometer; the gap gives RHHVAC technicians
Dew point hygrometerFinds the temperature at which air becomes saturatedLabs and building diagnostics

Read the accuracy before you set an alert

Every hygrometer has a tolerance, and it changes where you should set a warning. The Amazon listing for GoveeLife’s Wi-Fi thermo-hygrometer sensors gives plus or minus 3 percent RH. If one of them shows 57 percent, the true value can be anywhere from 57 minus 3 = 54 to 57 + 3 = 60 percent. To keep a basement reliably under 60 percent, set the alert at 60 minus 3 = 57 percent. A multi-sensor kit such as the GoveeLife Wi-Fi hygrometer kit with gateway can send that alert to your phone from the basement, the crawl space, and an upstairs closet at once.

Relative humidity and dew point

RH changes with temperature, which is why the same air can be fine in a warm room and wet on a cold pipe. The Magnus approximation turns temperature and RH into a dew point: gamma = ln(RH / 100) + 17.62 x T / (243.12 + T), then dew point = 243.12 x gamma / (17.62 minus gamma), with T in degrees Celsius.

For a basement at 68°F (20°C) and 60 percent RH: gamma = ln(0.60) + 17.62 x 20 / 263.12 = minus 0.511 + 1.339 = 0.828, so dew point = 243.12 x 0.828 / (17.62 minus 0.828) = about 12°C, or about 54°F. Any cold water pipe or foundation wall below 54°F will sweat. Drop the RH to 50 percent and the same math gives about 9°C, or about 49°F, which keeps most surfaces dry. Our page on the ideal basement humidity level uses these targets, and what size dehumidifier do I need turns a high reading into a pint rating.

Check yours with the salt method

A saturated table salt solution holds the air above it at about 75 percent RH: published values for sodium chloride run 75.7 percent at 68°F and 75.3 percent at 77°F. That makes a simple accuracy check.

  • Put a spoonful of table salt in a bottle cap and add a few drops of water until it forms a damp slurry with no standing liquid.
  • Seal the cap and the hygrometer in a zip-top bag, in a room that holds a steady temperature.
  • Wait 8 to 12 hours, then read the display without opening the bag.
  • Subtract 75 from the reading. A display of 72 means the unit reads 3 points low, so add 3 to every reading or use the offset setting if it has one.

Hygrometer vs hydrometer

The two names differ by one letter and measure different things. A hygrometer measures water vapor in air. A hydrometer floats in a liquid and measures its density, or specific gravity, which is how brewers track fermentation and how technicians check the electrolyte in flooded lead acid batteries. For humidity in a house, you want the hygrometer.

A hygrometer tells you when the air is wet; it will not tell you when water is on the floor. For that, pair it with a leak sensor at the water heater and sump pit, and see our best water leak detectors guide for models with phone alerts.

Changelog: November 2026: first published.