Brush or spray soapy water on the hose, regulator, and burner connections with the cylinder valve open. Bubbles mean gas is escaping. Turn the cylinder valve off right away. Both NFPA and CPSC describe this soapy-water check for gas grills.

What You Need

  • Dish soap mixed with water in about equal parts (a CPSC fact sheet gives one part detergent to one part water), in a spray bottle or with a brush. NFPA mentions a soapy mixture like children’s bubbles.
  • An outdoor spot away from the house, with burner knobs off and the lid open.
  • No lighter, no match, no cigarette. Never use a flame to look for a leak.

Steps

  • Make sure every burner knob is off.
  • Open the cylinder valve fully, as CPSC describes, or as your manual directs.
  • Spray or brush the soapy mixture along the hose, at the regulator, and at each connection to the cylinder and the burner assembly.
  • Watch for 30 seconds or so. Bubbles forming or growing mean a leak.
  • If you see bubbles, turn the cylinder valve off immediately (NFPA).
  • Rinse the soap off afterward.
Where to checkWhat a leak looks like
Cylinder valve and connectorBubbles at the threaded joint
RegulatorBubbles at either end of the regulator
HoseBubbles along cracks or kinks; look for brittle spots
Burner connectionBubbles where the hose meets the manifold

If You Find a Leak

Close the cylinder valve. Tighten a loose connection by hand if your manual allows it, then repeat the check. If bubbles continue, do not use the grill. Replace damaged parts with the manufacturer’s parts, or have a propane retailer or qualified technician repair it. Do not tape, patch, or modify hoses, regulators, or valves yourself.

If you smell strong gas, or smell gas while the grill is lit, turn the gas off if you can reach it safely, move everyone away from the grill, and call the fire department or 911 from a safe distance. Do not light anything.

Signs Without Bubbles

  • A rotten-egg or sulfur smell near the grill. Propane is given that odor so you can notice a leak.
  • A hissing sound near the regulator or hose.
  • A flame that is weak or yellow, or burners that will not stay lit. These can point to a gas-flow problem; see how to light a gas grill safely.

The warning signs above are general propane-safety advice, not wording from an agency page, so rely on the soapy-water check as the confirmation.

Common Mistakes

  • Checking with the valve closed. Soap only shows a leak when gas is under pressure, so the cylinder must be open.
  • Skipping the burner end of the hose, where heat and grease wear parts faster.
  • Using a lit match to confirm a smell. Use soapy water only.

How Often

NFPA says to check propane grills for leaks before use; the start of the season is the usual time. Check again whenever you swap or reconnect a cylinder, or if the grill was moved or knocked over. NFPA’s 2020 to 2024 annual averages show leaks or breaks caused 6 percent of gas grill structure fires and 13 percent of outside gas grill fires.

Changelog: November 2026: first published.