Season a new pellet grill by running it empty, with pellets in the hopper and no food, through the burn-in your manufacturer lists before the first cook. Traeger, for example, calls it a one-time initial firing. On its WiFIRE grills: prime the auger, run 20 minutes at 350°F, then 30 minutes at 450 to 500°F, then shut down. That is about 50 minutes at temperature, plus startup and shutdown.

Check Your Own Brand First

The 350°F and 450°F steps above are Traeger’s published numbers for its WiFIRE grills. Traeger lists different steps for its Woodridge and non-connected grills, and other brands print their own temperatures and times. Open the owner’s manual and follow it. If the manual and a video disagree, the manual wins.

Burn-In Steps (Traeger WiFIRE Example)

  1. Set the grill outdoors on a level spot, away from the house, deck railings, eaves, and branches (NFPA). Never inside a garage or enclosed area.
  2. Remove any packing material, foam, or stickers from the cooking chamber and grates.
  3. Plug the grill in, fill the hopper with hardwood pellets, and prime the auger until pellets drop into the fire pot, then stop the auger.
  4. Set 350°F, ignite, close the lid, and run 20 minutes once the grill reaches 350°F.
  5. Raise the setting to 450°F (Traeger’s page says 450 to 500°F) and run another 30 minutes once it gets there.
  6. Start the shutdown cycle and let it finish. The grill stays hot after the fire goes out, so keep your hands, children, and pets away.

Plan the Time and Pellets

PhaseMinutes at temperature
350°F hold20
450°F hold30
Total at temperature50

Warm-up between holds and the shutdown cycle add time, so set aside about an hour and a half. Traeger gives about 1.5 hours for a WiFIRE grill and roughly an hour for a non-connected one, which runs a different sequence. For fuel, Kingsford puts pellet grills at about 1 lb per hour at low heat and 2 lb per hour at high heat. Calculation: 1.5 hours x 1 to 2 lb is about 1.5 to 3 lb of pellets, only an estimate because burn-in sits at the upper end of the heat range. Details in how many pellets a pellet grill uses.

Mistakes to Avoid

  • Skipping the prime and letting the grill try to light on an empty fire pot.
  • Opening the lid to peek during the hold.
  • Using the wrong fuel. Use pellets made for cooking, as your manual specifies.
  • Running it in a garage, on a covered porch, or against siding.
  • Putting food on the grate during burn-in.

If you see flames outside the cooker during the burn-in, shut the grill off, keep the lid closed, move away, and call 911 if the fire spreads. Never throw water on a grease fire. A new grill has no grease yet, so keep this habit for later cleaning: how to clean a pellet grill. For first cooks in winter, see how to use a pellet grill in cold weather, and for the sourcing behind our advice, how we choose.

Changelog: November 2026: first published.