Yes, portable solar panels work in winter and in cold air; what shrinks the harvest is shorter days, a low sun, and snow on the glass. A 200 W panel in a Minneapolis December makes about 370 Wh a day, roughly half its June figure, and a panel buried in snow makes close to nothing.

Cold Helps the Panel, Short Days Hurt the Harvest

Silicon cells lose power as they heat up. As an example, the datasheet for the Renogy RSP200D, a rigid framed 200 W panel, lists a power coefficient of -0.37 percent per °C and a voltage (Voc) coefficient of -0.28 percent per °C, both measured from 77°F (25°C). Folding panels can list different coefficients, so check your own datasheet. A cell 35°C colder than that, about 14°F, would gain roughly 0.37 x 35 = 13 percent in power and 0.28 x 35 = 10 percent in voltage. That is a best case, because winter light is weak and a cell in cold air still warms in sun.

The bigger loss is sunlight. NASA POWER climatology (2001 to 2025) gives these averages for a panel tilted at latitude, in kWh per square meter per day, which equals peak sun hours:

CityDecemberJuneDecember as share of June
Seattle1.694.98about 34%
Minneapolis2.455.28about 46%
Chicago2.385.24about 45%
Denver4.176.39about 65%

A Winter Example: 200 W in Minneapolis

Daily output = panel watts x peak sun hours x 0.75 real-world derate (a common planning figure for heat, wiring, and angle loss). In December: 200 W x 2.45 x 0.75 = about 370 Wh. In June: 200 W x 5.28 x 0.75 = about 790 Wh. A 1,024 Wh power station would take about 1,024 / 370 = 2.8 clear days to fill from empty in December, versus about 1.3 in June. Plan winter backup with about twice the panel watts you would use in summer, or count on a second charging source.

Tilt Matters More in Winter

NASA POWER puts Minneapolis in December at 1.33 for a flat panel and 2.45 for one tilted at latitude, so tilting gains about 84 percent (2.45 / 1.33 = 1.84). Prop a folding panel nearly upright and aim it at true south, which also helps snow slide off. A flat panel on a patio table gives up most of its winter output.

Snow, Voltage, and Cold Batteries

  • Snow: clear it before the sun is up so the panel starts producing sooner. Use a soft broom from the ground; stay off icy roofs and away from where power lines enter the house, as the Insurance Institute for Business and Home Safety (IBHS) advises for roof snow work.
  • Voltage: cold raises Voc, so a string that fits under the limit on a warm day can exceed the maximum input voltage of your power station or charge controller on a freezing morning. Check the cold Voc against the limit in its manual. Using the RSP200D example, a 23.0 V Voc panel at about 14°F reads roughly 23.0 x 1.10 = 25 V, and a series string multiplies that by the number of panels.
  • Battery: the battery limits charging more than the panel does. Jackery lists 32 to 113°F charging for the Explorer 2000 v2, and Battle Born standard models do not charge below 32°F. Keep the station indoors and run the panel cable in through a window or door.

For the full cold-weather picture, see our power station in cold weather guide. To size panels, use how many watts of solar to charge a power station, and compare foldable and framed panels in portable vs rigid solar panels. Our panel picks are in best solar panels for power stations, and the charging steps are in how to charge a power station with solar.

Changelog: November 2026: first published.