Restart in order: modem, then router, then the camera. Wait until your internet light is steady before touching the camera, because a camera that boots before the network is up often fails to rejoin Wi-Fi. If the camera still shows offline after that, power cycle it once. A factory reset is the last step, not the first.
Reset order after the lights come back
- Check the outlet or injector first. A tripped GFCI outlet or a dead power adapter looks the same as a camera that will not reconnect. PoE cameras get power from the switch or injector, so confirm that unit has power too.
- Restart the modem, then the router. Unplug each, wait about 30 seconds, plug the modem in, and give it a few minutes to finish booting before powering the router.
- Power cycle the camera. Unplug it (or pull the battery and reinsert it), wait 10 seconds, and power it back up. Watch the status light and compare it with the light guide in your manual.
- Check the network name and password. If the router reset to defaults during the outage, the camera is looking for a network that no longer exists. Rejoin it from the camera app.
- Confirm the clock and storage. Recordings with the wrong timestamp or missing clips usually mean the camera lost its time or its microSD card was not read after the abrupt power loss. Reseat the card and re-sync the clock in the app.
- Factory reset last. Use the reset pinhole or button exactly as your manual describes. It erases settings and pairing, so you will set the camera up again from scratch.
Why a camera stays offline
| Symptom | Likely cause | First fix |
|---|---|---|
| No status light | No power at outlet, adapter, or PoE switch | Check the GFCI and the adapter |
| Light on, app says offline | Router or modem not ready, or Wi-Fi credentials changed | Restart modem, then router, then camera |
| Online, no recordings | SD card not mounted or clock wrong | Reseat the card, re-sync the time |
| Works for a minute, then drops | Weak signal or a damaged adapter after a surge | Move closer to the router; swap the adapter |
Keeping cameras up next time
A camera is only useful during an outage if the router and modem stay powered too. Add up the running watts and divide into usable battery capacity. Example with assumed loads: modem 8 W, router 12 W, two cameras at 5 W each is about 30 W. A 200 Wh backup unit at roughly 85 percent inverter efficiency gives 200 x 0.85 / 30 = about 5.7 hours. Check your own devices’ labels, because the real numbers differ. For units that switch over without dropping the connection, see our power stations with UPS mode guide.
Battery cameras keep running through an outage but still need the router to reach your phone. Local-storage cameras keep recording to the card without internet, which is why a card that mounts correctly matters. Outage planning in general is covered in how to prepare for a power outage and the first 24 hours, and power outage essentials lists what to have on hand.
Common mistakes
- Rebooting the camera while the router is still starting, then reading the failure as a dead camera.
- Jumping to a factory reset, then losing the settings and the pairing for a problem the router restart would have fixed.
- Plugging cameras and the router into the same strip with no surge protection. Voltage spikes when power returns can damage adapters.
Changelog: November 2026: first published.