Winterize an outdoor faucet in four steps before the first night below 32°F: disconnect and drain the hose, close the indoor shutoff valve that feeds the faucet, open the outdoor tap so the trapped water drains and has room to expand, and fit an insulated cover. The first three come from American Red Cross freeze guidance, and the IBHS adds insulating outdoor spigots to its winter list. Frost-free faucets skip the indoor valve but still need the hose removed.

Which Kind of Outdoor Faucet You Have

Identify the faucet first, because the two common types winterize differently.

TypeHow to recognize itWhere the valve closesWinter job
Standard hose bibShort body; a separate shutoff valve on the pipe inside the basement or crawl spaceAt the faucet, outside the wallClose the indoor valve, drain, leave the outside tap open
Frost-free sillcockLong valve stem; the handle sits on a body that extends back through the wallInside the heated wall, several inches inRemove the hose so the tube drains; no indoor valve needed
No indoor shutoff foundStandard bib with no valve on the inside lineAt the faucet onlyCover it, and have a plumber add a shutoff before deep cold

Manufacturers such as Woodford explain the frost-free design this way: the seat that stops the water sits inside the house, so when you close the handle, the water left in the outdoor section runs out of the spout. That only works when the faucet is pitched slightly downward toward the outlet and nothing blocks the spout.

Steps for a Standard Hose Bib

  1. Disconnect the hose and drain it. Coil it and store it out of the weather. A connected hose holds water against the faucet.
  2. Find the indoor shutoff valve. Follow the pipe from the faucet’s location inside the basement, crawl space, or utility room. It is usually within a few feet of the wall.
  3. Close the indoor valve. Turn it clockwise until it stops, or turn a quarter-turn lever across the pipe.
  4. Open the outdoor tap and leave it open. The Red Cross advises keeping the outside valve open so any water left in the pipe can expand without breaking it.
  5. Drain the short section between the valves. Some indoor valves have a small drain cap on the side. Hold a bucket under it and loosen the cap to let the last water out, then close it.
  6. Fit an insulated faucet cover. It slows heat loss from the wall around the faucet. It does not replace closing and draining the line.

Steps for a Frost-Free Faucet

  1. Remove the hose every time the forecast reaches freezing. On most models, with a hose attached, the water in the outdoor tube cannot drain, and the tube can split inside the wall. Woodford prints “remove hose or faucet may freeze and burst” on the flange of its standard models.
  2. Close the handle and let the spout drip out. A short trickle after closing is the tube emptying.
  3. Check the pitch. If water stands in the spout, the faucet may be level or tipped back; have a plumber reset it.
  4. Follow the manual for any vacuum breaker. Some models drain through a removable breaker cap; the steps differ by brand and model.
  5. Add a cover in hard-freeze climates. It protects the part of the body that sits in the wall cavity.

A split in a frost-free faucet’s tube often stays hidden until spring, when you open the faucet and water runs inside the wall instead of out the spout. Watch the basement or crawl space the first time you use it, or place a leak sensor below it. Our guide on where to put water leak detectors covers that spot.

Why the Open Tap Matters: The Math

Ice needs more room than the water it came from. The U.S. Geological Survey notes that ice is about 9 percent less dense than liquid water, so the same weight of water takes up roughly 9 percent more space when it freezes.

Take 10 ft of pipe with about 1/2 in inside diameter between the indoor valve and the faucet. The cross section is 3.14 x 0.25 in x 0.25 in = about 0.196 sq in, so the pipe holds 0.196 x 120 in = about 23.6 cu in of water, or 23.6 / 231 cu in per gallon = about 0.1 gallon. Frozen, that water needs 23.6 x 0.09 = about 2.1 cu in of extra room, the same as 2.1 / 0.196 = about 11 more inches of pipe. A closed tap leaves nowhere for it to go. An open tap and a drained line remove the problem.

Common Mistakes

  • Leaving the hose on a frost-free faucet. The design depends on the tube draining.
  • Closing the indoor valve but leaving the outdoor tap shut. Water stays trapped between the two.
  • Relying on a foam cover alone on a standard bib with water still in the line.
  • Forgetting sprinkler and pool lines. The Red Cross says to drain them following the manufacturer’s or installer’s directions, without antifreeze unless directed.

Outdoor Faucet Checklist

  • Hoses off, drained, and stored
  • Indoor shutoff closed on each standard hose bib; drain cap opened and closed again
  • Outdoor taps left open on standard bibs
  • Frost-free faucets clear of hoses and draining from the spout
  • Insulated covers on
  • Sprinkler and pool lines drained per installer directions
  • Leak sensor below any faucet that has failed before

Outdoor faucets are one line on the full fall list in our guide on how to winterize a house. For the indoor pipes, see how to keep pipes from freezing. If a hose bib line freezes anyway, use our steps on how to thaw frozen pipes safely, and if a winter outage takes the heat with it, our heaters for power outages guide compares safe options.

Changelog: November 2026: first published.