A UPS (uninterruptible power supply) battery backup is a plug-in box with a built-in battery that keeps electronics running for a few minutes when the power drops, switching over fast enough, typically within about 10 milliseconds, that a computer or router does not shut off. Its job is to bridge the gap: long enough to save work and shut down cleanly, or to keep a modem and router online through a short flicker.
What a UPS does for a homeowner
A UPS handles the short outages and voltage dips behind many nuisance restarts. A desktop PC that loses power for a fraction of a second reboots and can lose open files; a router that reboots drops your internet, and any Wi-Fi leak sensors or cameras with it, until it finishes restarting. A UPS covers both, and most models also include surge protection. For the router case specifically, see our guide to the best UPS for a modem and router.
How a UPS works: three designs
Every UPS charges a battery from the wall and runs an inverter from that battery when needed. The three common designs differ in when the battery takes over, as Eaton’s UPS topology paper describes:
| Design | How it works | Typical home use |
|---|---|---|
| Standby (offline) | Passes wall power through until it detects a problem, then switches to battery | Routers, modems, a home office PC |
| Line-interactive | Boosts or trims voltage during sags and surges before falling back to battery | Homes with frequent brownouts |
| Online (double conversion) | Converts all power AC to DC and back, so the load always runs from the inverter | Servers and sensitive equipment |
Most consumer units are standby or line-interactive. APC’s Back-UPS BE600M1, a common entry model, is rated 600 VA and 330 W, with a transfer time of 6 ms typical and 10 ms maximum on its datasheet.
How long a UPS runs: minutes, not hours
A small UPS runs for minutes because its battery is small. The BE600M1 uses APC’s APCRBC154 cartridge, a 12 V, 6.5 Ah lead-acid battery, which is 12 x 6.5 = 78 Wh on the label. Retailer listings give about 12 to 15 minutes at half load (165 W), depending on the listing. That works out to 165 W x (12 / 60) = about 33 Wh to 165 W x (15 / 60) = about 41 Wh delivered, roughly half the label or less, partly because lead-acid batteries give up less energy when drained quickly. Light loads such as a 15 W router drain the battery more slowly and stretch further, so check APC’s runtime chart for your exact wattage.
UPS battery life expectancy
Plan to replace a UPS battery every 3 to 5 years. Schneider Electric’s APC support FAQ says most APC batteries should last three to five years, and that every 8°C (15°F) rise in temperature cuts battery life in half. Keep the unit off a hot floor behind a gaming PC, and replace the cartridge when the unit shows its replace-battery warning, whatever its age.
UPS vs a power station with UPS mode
A UPS is built for fast switching and short runtime; a portable power station with UPS mode trades a slower or similar switchover for far more stored energy. A 1,024 Wh station such as the EcoFlow DELTA 3 Classic, which EcoFlow lists with a 10 ms UPS switchover, holds about 1,024 / 78 = about 13 times the label energy of the BE600M1 battery, and uses lithium iron phosphate cells instead of lead-acid. It is also larger and heavier. Our explainer on UPS mode on a power station compares switchover times across models.
| Small UPS | Power station with UPS mode | |
|---|---|---|
| Stored energy | Tens of Wh | About 1,000 Wh and up |
| Runtime on a router | Minutes to a few hours, depending on load | About a day or more |
| Battery | Sealed lead-acid, replace every 3 to 5 years | Usually LiFePO4 |
| Best use | Clean shutdown, short flickers | Riding out a multi-hour outage |
Neither one replaces a plan for a long outage. For that, start with how to prepare for a power outage and our list of power outage essentials.
Changelog: November 2026: first published.