Press the test button on every smoke alarm once a month. NFPA says to push it once and listen for the loud beep, beep, beep, which means the alarm is working. If it stays silent, change the battery, and if the unit is over 10 years old, replace the whole alarm.

The monthly check, step by step

  1. Warn the household. The horn is loud, and a sleeping child or a pet will not know it is a check.
  2. Press the test button. NFPA says to push it once. Your manual says how long to hold it for your model.
  3. Listen for the full horn. Beep, beep, beep means it works. A weak, partial, or silent response means the battery or the unit has a problem.
  4. Repeat on every alarm. Walk every bedroom, hallway, and level, including the basement.
  5. On interconnected alarms, NFPA says that when one sounds, they all sound. If only the one you pressed sounds, the link may be broken: check the manual, and call a licensed electrician for hardwired systems.
  6. Write down the date. A note on your phone calendar is enough.

What the sounds mean

What you hearMeaning (NFPA)Do this
Loud beep, beep, beepSmoke or fireGet out, call 911, and stay out
One chirp every 30 or 60 secondsLow batteryChange the battery
Chirping continues after a new batteryEnd of lifeReplace the whole alarm
Silence when you press the buttonDead battery, no power, or failed unitChange the battery; replace if it stays silent

Patterns differ by brand, so match them against your user guide. The silence row follows NFPA’s installation guide: replace an alarm that does not respond when you press the button, even after a new battery.

How long the whole house takes

Assume about 30 seconds per alarm, including the walk. A 6-alarm house: 6 x 30 s = 180 s, or 3 minutes a month. Over a year that is 12 x 3 = 36 minutes. NFPA’s installation guide says smoke alarms fail most of the time because of missing, disconnected, or dead batteries, which is the failure this routine catches.

Common mistakes

  • Silencing a nuisance alarm by pulling its battery and not putting it back. Move the cause, not the battery. NFPA says alarms belong at least 10 feet from the stove, and photoelectric types suit areas near kitchens and bathrooms.
  • Checking only the one in the hallway. Bedrooms and the basement count. See where to place smoke detectors.
  • Trusting an old alarm that still beeps. The button shows the horn works, but NFPA still says to replace the unit 10 years after manufacture. Read how often to replace smoke detectors.
  • Ignoring hardwired battery backups. NFPA notes that most hardwired alarms are required to have one, so they need fresh batteries too.

NFPA adds that you can clean alarms by following the manufacturer’s instructions in the package or online. For CO alarms the same monthly button check applies, per CPSC; the smoke vs CO comparison explains how they differ. If a check shows you need new units, start with the combo alarm comparison.

Changelog: November 2026: first published.