Open the lid, check the hose and connections, open the cylinder valve slowly, then turn one burner on and press the igniter. If the burner has not lit within a few seconds, turn it off, leave the lid open, and wait 5 minutes before trying again. The lid and 5-minute rules come from NFPA and Weber’s manuals; your grill’s manual is the final word for your model.
Before You Light
- Grill outside, with space around it. CPSC says to use grills outdoors only, in a well-ventilated area, never in a garage, breezeway, carport, or porch, or under anything that can burn.
- Keep it away from the house. NFPA says to set the grill well away from the home, deck railings, eaves, and overhanging branches. NFPA also advises keeping kids and pets at least 3 feet from the grilling area.
- Check for leaks first if the cylinder was just connected or the grill has sat all winter. The steps are in how to check a propane grill for leaks.
- Clear grease from the trays below the burners (NFPA).
Lighting Steps
- Open the lid fully. NFPA says to always make sure the lid is open before lighting a gas grill.
- Make sure all burner knobs are off.
- Open the cylinder valve slowly, one full turn or as your manual directs.
- Turn one burner knob to high and press the igniter. Hold the knob in if your model needs it.
- Confirm the flame is lit through the cooking grate before turning on the next burner.
- Close the lid to preheat after all burners are lit.
If It Does Not Light
Turn the burner knob off (and the cylinder valve, if your manual says so). Leave the lid open and wait 5 minutes to let the gas clear before you try again. Weber’s manuals say that failing to open the lid while igniting the burners may result in an explosive flame-up. If you smell gas at any point, see the section below.
| Symptom | Common cause | What to do |
|---|---|---|
| Clicks but no spark or flame | Dead igniter battery or dirty electrode | Replace the battery if your model uses one; wipe the electrode area |
| Sparks, no flame | No gas reaching the burner, or an empty cylinder | Check the cylinder level and that the valve is open |
| Weak or uneven flame | Blocked burner ports or a tripped regulator | Follow your manual’s reset steps |
| Igniter fails completely | Failed igniter module | Use the match-lighting instructions in your manual |
The causes above are common troubleshooting patterns rather than agency findings, so use your grill’s manual. For regulator problems or damaged hoses, contact the manufacturer or a qualified technician. Do not modify valves or regulators.
If You Smell Gas
Turn the burner knobs and cylinder valve off, keep flames and sparks away, and do not light anything. If you smell gas while the grill is already lit, turn the gas off if you can reach it safely, move everyone away, and call the fire department or 911 from a safe distance. Do not try to move the grill. Otherwise, check the connections with soapy water before using the grill again, and if the smell continues or is strong, move everyone away and call your gas supplier or 911.
Match Lighting
Many grills have a match-light hole. Follow your manual exactly, use a long-reach lighter or a match holder, and keep your face and hands away from the burner. If your grill does not mention match lighting, do not improvise.
After Cooking
Turn the burner knobs off, then close the cylinder valve. Let the grill cool before covering it. Store spare cylinders outdoors and upright, as covered in how to store a propane tank safely. Estimating fuel? See how long a 20 lb tank lasts.
Changelog: November 2026: first published.