Table of Contents

4 sections 3 min read

A multimeter on the terminals gives you resting voltage, which is a rough state-of-charge reading. For a flooded 12 V deep cycle battery, Trojan’s data sheet puts a full charge at 12.73 V and 50 percent at 12.10 V. It does not measure capacity. For that you need a load or a timed discharge.

Before You Start

  • Wear safety glasses and remove jewelry. Discover Battery says to keep terminals from touching metal mounts or your body, and never to lean over a battery while checking or charging it.
  • Let the battery rest with no charger and no load. Trojan’s maintenance guide says a battery should sit idle (no charging, no discharging) for at least 6 hours, preferably 24 hours, and its FAQ gives one hour as a minimum for a quick check. A reading right after charging reads high. Disconnect all loads first.
  • Set the meter to DC volts (20 V range). Red probe to positive, black to negative.

Read the Voltage

These resting voltages for a flooded 12 V battery come from Trojan’s T-1275 data sheet. Other makers’ charts vary by chemistry and design, so treat any chart as typical, not exact:

Resting voltage (flooded, Trojan)Charge
12.73 V100%
12.50 V80%
12.24 V60%
12.10 V50%
11.96 V40%
11.66 V20%

AGM and gel batteries have their own charts, so use your battery maker’s chart when it has one. Trojan also notes that voltage alone is a rough guide and that specific gravity is the most accurate way to read state of charge in flooded batteries. Discover Battery suggests a boost charge when a stored battery falls below 75 percent, about 12.40 V. LiFePO4 batteries hold a flat voltage across most of their range, so check those with the battery’s own monitor or app.

Check Capacity With a Load

A good resting voltage can hide a worn battery. Charge fully, rest it, then run a known load and time it. Capacity (Ah) = load amps x hours until the maker’s low-voltage cutoff. Example: a 100 Ah battery drawing 5 A that reaches cutoff after 14 hours delivered 5 x 14 = 70 Ah, or 70 percent of rated. Many deep cycle batteries are rated at the 20-hour rate, so confirm on the label. Stop at the cutoff, because deeper discharge shortens life. A dedicated battery load tester is a quicker alternative.

When to Replace

If a fully charged, rested battery will not reach the voltage in its chart, or drops fast under load, charge it again and recheck. A battery that keeps failing is a replacement candidate. Check the warranty first.

Related: how to store a deep cycle battery for winter, charging with a generator, charging with solar panels, and LiFePO4 vs lead-acid. See how we choose for our research method.

Changelog: November 2026: first published.