The X-Sense SC07 is the smoke and carbon monoxide combo alarm we recommend for most existing homes: one ceiling unit pairs a photoelectric smoke sensor with an electrochemical CO sensor, runs on a sealed battery rated for 10 years, and shows the CO level on an LCD. Its one real limit is that the basic SC07 does not interconnect, so it fits best in a house that already meets its local code and needs CO coverage added at each level and outside sleeping areas. Homes wired for interconnected alarms should look at the hardwired Siterwell combo below.

A combo alarm earns its place where you need both sensors in the same spot, which is the hallway outside the bedrooms and the common area on each level. Inside bedrooms, NFPA guidance calls for a smoke alarm, while CPSC guidance places CO alarms on each level and outside sleeping areas, which is why a smoke-only alarm closes out this guide. For CO-only units, see our separate guide to carbon monoxide detectors; we kept the two lists apart on purpose.

Five combos from four brands, ranked, then a smoke-only alarm for bedrooms. They split three ways: sealed 10-year battery units, a replaceable-battery unit, and a hardwired interconnected unit.

Quick Comparison

Figures come from maker pages, manuals, and spec sheets where we found them, and otherwise from the listing; the Standards column names the source.

PickDetectsSmoke sensorPowerInterconnectStandards (source)UnitsBest for
X-Sense SC07Smoke and COPhotoelectricSealed lithium, 10-year lifeNoUL 217 and UL 2034 (X-Sense)1Adding CO to one hallway or level
X-Sense XP0H-SN (3-pack)Smoke and COPhotoelectric (listing)Sealed lithium, 10-yearNoUL 217 and UL 2034 (listing)3Covering three levels at once
First Alert SMICO100Smoke and COIonizationReplaceable 9 VNoUL 217 and UL 2034 (First Alert spec sheet)1Adding an ionization sensor beside photoelectric units
Siterwell GS886F-H02Smoke and CO, voice alertsPhotoelectricHardwired, sealed 10-year backup batteryWired, up to 18 alarmsUL 217 and UL 2034 (listing)1Replacing hardwired alarms
Heiman HM-636THSSmoke and COPhotoelectricSealed lithium, 10-yearNoUL 217 and UL 2034, CSFM (listing)1A small, low-profile ceiling unit
First Alert SMI100 (2-pack)Smoke onlyIonizationReplaceable 9 VNoMeets newer cooking-nuisance requirements, per First Alert2Bedrooms, where a CO unit is optional

How We Chose

A combo alarm had to be listed to two standards, UL 217 for smoke alarms and UL 2034 for residential CO alarms, as stated by the maker or, where no maker document was available, the listing; the table says which. After that, we weighed the power source, because a sealed 10-year battery removes the chance of a dead or borrowed battery leaving the alarm silent, the smoke sensor type, interconnect options, and the Yard & Grid Score built from verified buyer ratings.

Our sources were manufacturer manuals and listings, NFPA smoke alarm tip sheets and installation guidance, NFPA 72 replacement rules as quoted by code publications, the CPSC Carbon Monoxide Questions and Answers page, and patterns in public owner reviews. We research and compare; we do not run our own product trials or expose alarms to smoke or CO. The full method is on our How We Choose page.

1. X-Sense SC07 Smoke and Carbon Monoxide Alarm

  • X-Sense lists the SC07 to UL 217 (its product page cites the 9th edition) and UL 2034, with a photoelectric smoke sensor and an electrochemical CO sensor in one housing.
  • A sealed 3 V lithium supply powers it for a 10-year product life. There is no battery door, so nobody can pull the battery to stop a nuisance chirp and forget to put it back.
  • The LCD shows the CO level in ppm, which tells you whether a reading is climbing before it reaches the UL 2034 alarm windows.
  • X-Sense states plainly that the SC07 is standalone: no wireless interconnection, no Wi-Fi, no base station. The interconnected version is a different model, the SC07-W.
  • Because units do not interconnect, a fire in the basement sounds only the basement alarm, which is a real gap when bedrooms are two floors up.

Best for: an existing home with working smoke alarms that needs CO coverage added in the hallway outside the bedrooms, with no wiring and no battery chores.
Avoid if: you are building or renovating where code calls for interconnected alarms, or you want every alarm in the house to sound when one does.

2. X-Sense XP0H-SN Smoke and CO Alarm (3-pack)

  • A sealed 10-year lithium combo sold three to a box, which matches a house with a basement and two floors; units bought together reach end of life together.
  • The listing claims UL 217 and UL 2034 certification and lists a photoelectric smoke sensor. The LCD shows the CO level and battery status, stays dark in standby, and the unit runs a self-check every 60 seconds.
  • A 5.7 in (145 mm) mounting bracket, larger than most, covers screw holes and ceiling stains left by an old alarm.
  • Standalone like the SC07: no interconnect, no Wi-Fi, no base station. X-Sense sells the interconnected version as the XP0H-WN. The listing gives a 5-year quality warranty.

Best for: replacing a set of aging battery alarms on three levels in one weekend.
Avoid if: you need the alarms to sound together.

3. First Alert SMICO100 Smoke and CO Alarm

  • First Alert’s spec sheet pairs an ionization smoke chamber with an electrochemical CO sensor and lists the alarm as certified to UL 217 and UL 2034, with an 85 dB horn at 10 ft.
  • It runs on a replaceable 9 V battery, with locking pins for the battery drawer and the mounting bracket, and a latching light that shows which unit alarmed after the event.
  • The only ionization combo here. NFPA notes ionization alarms respond faster to flaming fires, so one beside photoelectric units gives the house both sensor types.
  • The listing also names the SMCO100, a photoelectric First Alert model that runs on AA cells, while its model and sensor fields say SMICO100 and ionization. Check the box when it arrives.
  • First Alert lists a 10-year limited warranty.

Best for: a main-floor living area near the kitchen, paired with photoelectric combos elsewhere.
Avoid if: you want no battery changes for a decade.

4. Siterwell GS886F-H02 Hardwired Smoke and CO Alarm

  • The hardwired pick. The listing describes a household-current alarm with a sealed 10-year backup battery, wired interconnect for up to 18 alarms, and photoelectric smoke sensing.
  • Voice alerts in English and French announce fire or carbon monoxide, which helps a sleepy household tell the two apart.
  • The listing claims UL 217 and UL 2034 certification; we found no Siterwell spec sheet to confirm it.
  • Installing or swapping hardwired alarms is household wiring and a job for a licensed electrician. Connector harnesses differ by brand, so moving from another brand can mean new wiring.

Best for: homes that already have hardwired, interconnected alarms, or a renovation where code calls for them.
Avoid if: you rent, or you want a battery unit you can mount yourself today.

5. Heiman HM-636THS Smoke and CO Alarm

  • A sealed 10-year combo with photoelectric and electrochemical sensors and an 85 dB alarm, per the listing.
  • The listing claims UL 217 and UL 2034 certification and California State Fire Marshal approval. It names standard editions we could not confirm in a public directory.
  • At 4.91 in across and 6.4 oz it is the smallest unit here, and a red light flashes every 20 seconds after an alarm went off while you were out.
  • The listing gives a 10-year limited warranty, twice the 5 years on the X-Sense listings.

Best for: a low ceiling or a spot where a large disc would look out of place.
Avoid if: you want a brand with a longer track record in US stores.

6. First Alert SMI100 Battery Smoke Alarm (2-pack)

  • A smoke-only alarm. It is here because bedrooms need smoke alarms under NFPA guidance, and CPSC guidance asks for CO coverage outside sleeping areas rather than in each bedroom.
  • First Alert lists it as an ionization alarm. NFPA notes ionization alarms respond faster to flaming fires and photoelectric alarms to smoldering ones, so pairing it with the photoelectric SC07 in the hallway gives the house both types.
  • First Alert says its Precision Detection sensing meets newer industry requirements meant to cut nuisance alarms from cooking, which matters for alarms near a kitchen.
  • Runs on a replaceable 9 V battery behind a front-access door, and gives an end-of-life warning when the alarm itself needs replacing.
  • The trade-off against the sealed units is battery upkeep: a dead or missing 9 V leaves the alarm silent.

Best for: pairing with SC07 units in hallways so each bedroom gets its own smoke alarm.
Avoid if: you want CO detection in the same unit, or you know batteries in your house tend to go unchanged for years.

What a Combo Setup Costs Over 10 Years

Ten years is the right window because it is the replacement point for both alarm types. NFPA 72 says a combination smoke and CO alarm is replaced at its end-of-life signal or at 10 years, whichever comes first, and smoke alarms in general are replaced at 10 years.

  • Units. A sealed 10-year combo is one purchase per spot per decade. A separate smoke alarm and CO alarm in the same spot is two purchases, and if the CO unit is a 5-year model, it becomes 1 + 2 = 3 purchases per spot.
  • Batteries. Sealed units need none. A 9 V smoke alarm needs replacements on the schedule in its manual; if you follow the common twice-a-year clock-change habit, that is up to 2 x 10 = 20 batteries per alarm over a decade.
  • Warranty. The SC07 and XP0H-SN listings give 5 years; First Alert lists 10 years for the SMICO100 and the Heiman listing gives 10. Register the purchase and keep the receipt.

How to Choose: Questions to Ask First

How many combos and how many smoke-only alarms?

Split the count by room type. NFPA guidance puts smoke alarms in every bedroom, outside each sleeping area, and on every level. The CPSC puts CO alarms on every level and outside sleeping areas. The places both lists share are where combos belong. A simple formula: combos = levels + extra sleeping areas on the same level, and smoke-only alarms = bedrooms.

Worked example, a two-story house with a finished basement and three bedrooms upstairs off one hallway: combos = 3 levels + 0 extra sleeping areas = 3, and smoke-only alarms = 3 bedrooms = 3, for 6 alarms. Put combos in the basement, the main-floor living area, and the upstairs hallway, then a smoke alarm in each bedroom. Our guide on where to put a carbon monoxide detector covers mounting height and spots to avoid.

Do I need interconnected alarms?

Check your situation before you buy. NFPA notes that many jurisdictions require new homes to have smoke alarms hardwired into the electrical system, that most hardwired alarms must have battery backup, and that wireless interconnected alarms are now available; ask your building department what applies to a new build or renovation. For any home, NFPA recommends interconnected alarms so that when one sounds, they all sound. If interconnection matters to you, skip the standalone units; look at the wireless SC07-W family or a hardwired combo such as the Siterwell.

What about wired and smart combos?

A hardwired combo connects to a 120 V household circuit and an interconnect wire, usually through the plug-in harness of the alarm it replaces, and any work on household wiring is a job for a licensed electrician. Smart combos add phone alerts over Wi-Fi. Google ended production of the Nest Protect in March 2025 and pointed buyers to a First Alert smart alarm as its successor; installed Nest Protect units keep working until their expiration dates. Our product data does not include a smart combo yet.

Will a combo alarm sound fast enough for CO?

It sounds on the UL 2034 schedule, the same as a CO-only alarm. Kidde’s spec brochure summarizes that schedule as 70 ppm within 60 to 240 minutes, 150 ppm within 10 to 50 minutes, and 400 ppm within 4 to 15 minutes. That is why a ppm display, like the SC07’s or the XP0H-SN’s, is useful during outages, when fuel heaters and generators raise the risk. Keep any portable generator outdoors: the CPSC says at least 20 ft from the home, far from windows, doors, and vents, with the exhaust pointed away from the home. Our guide to carbon monoxide safety during power outages walks through the rest.

FAQ

Is a combo alarm as good as two separate alarms?

A combo listed to both UL 217 and UL 2034 meets the same standards a separate smoke alarm and CO alarm meet. The practical differences are placement and replacement: a combo goes on the ceiling or high on a wall like a smoke alarm, and both sensors retire together at end of life. Read carbon monoxide detector vs smoke detector for how the sensors differ.

How do I know when to replace a combo alarm?

Replace it at the end-of-life signal or 10 years after manufacture, whichever comes first, per NFPA 72. Write the install date on the unit, and check the manufacture date printed on the back. How long carbon monoxide detectors last explains end-of-life chirps by brand.

Should I put a combo alarm in the kitchen?

No. The CPSC advises against placing CO alarms in kitchens or above fuel-burning appliances, and First Alert recommends keeping smoke alarms at least 10 ft from cooking appliances. Mount the combo in the nearest hallway or living area instead.

What does NFPA 720 say about combo alarms?

NFPA 720 has been withdrawn, and its CO alarm requirements moved into NFPA 72 beginning with the 2019 edition. The 10-year replacement rule for combination alarms comes from NFPA 72. Your local code decides which edition applies.

Printable Checklist

  • Count levels, sleeping areas, and bedrooms.
  • Put combos where smoke and CO coverage overlap: each level and outside sleeping areas.
  • Put smoke alarms in every bedroom.
  • Confirm each combo is listed to UL 217 and UL 2034.
  • Decide whether code or your layout calls for interconnection before you buy.
  • Keep alarms out of kitchens and away from fuel-burning appliances.
  • Press the check button monthly and write the install date on each unit.
  • Replace at end of life or 10 years, whichever comes first.

Changelog: October 2026: first published. October 2026: added products after a catalog update.