Connect the maintainer to the battery first with the charger unplugged, then plug it into the wall, pick the mode that matches the battery chemistry, and leave it on float. Float is a very low current: Battery Tender puts it at 0.1 to 0.5 A regardless of the charger’s rating. The order of connection matters more than anything else on this list.
Step by Step
- Read the charger’s manual first. Clamp locations and mode names differ by model, and the manual overrides this list.
- Work in a ventilated space. NOCO’s user guide warns that lead-acid batteries generate explosive gases during normal operation, and says not to run the charger in a closed-in area or near sparks or flame.
- Confirm the charger is unplugged from the wall. NOCO’s guide says not to connect the AC plug until all other connections are made, because a spark near the battery may cause an explosion.
- Attach the red clamp to the positive terminal. For a battery still in the vehicle, attach the black clamp to the chassis or engine block away from the battery, on a heavy metal part and not near fuel lines, as NOCO’s guide directs for negative-grounded vehicles. Off the vehicle, use the negative terminal.
- Plug in the charger and select the mode. Lead-acid (flooded, AGM, gel) and LiFePO4 want different voltage curves. Battle Born, for example, lists absorption at 14.2 to 14.6 V for its LiFePO4 batteries, so confirm the charger has a lithium mode before connecting one.
- To remove it, unplug the charger from the wall first, then take off the black clamp, then the red. NOCO’s guide calls for the reverse of the connecting order, negative first.
How Often to Check
A maintainer should keep the battery at float, but confirm it once a month. Discover Battery says to give an AGM or gel battery a boost charge when it falls below about 75%, which it puts near 12.40 V resting. Measure with the charger unplugged and the battery rested. A resting reading under that means the maintainer, the clamps, or the battery needs attention.
Maintainer or Charger?
Battery Tender’s own range shows the split. Its Junior is listed for long-term maintenance and seasonal storage, while a higher-amp unit targets recovery. A maintainer holds a battery that is already charged. It will take a drained battery up slowly, as the math in how long it takes to charge a car battery shows. For a deep-cycle bank that sits all winter, see how to store a deep cycle battery for winter.
Common Mistakes
- Using a lead-acid mode on a LiFePO4 battery. Check the chemistry comparison in LiFePO4 vs lead-acid first.
- Clamping the black lead to the negative post on an in-vehicle battery, next to the gas the battery vents.
- Leaving a charger in a closed cabinet. Keep air moving around the battery.
If a battery is swollen, leaking, or hot to the touch, stop and have it inspected rather than keep charging. For a generator-fed charger, see charging a deep cycle battery with a generator.
Changelog: November 2026: first published.